Access Flashes while in Service Mode?

Gh0st-UPMS · Post by **Gh0st-UPMS** » Sat Mar 15, 2008 11:29 am

How do you access the flashes while running in service mode, as ms0 takes the role of flash0 and obviously anything you try to read/write returns ms0.

Would just like to know how this is done.

Thanks in advance.

adrahil · Post by **adrahil** » Sun Mar 16, 2008 1:25 am

Boot the MS IPL, load some of sony's PRXs and access flash normally. It is NOT recommended being a smartass and rerouting the TinyFat accesses to flash :) (Unless you want to destroy your IDStorage)

Gh0st-UPMS · Post by **Gh0st-UPMS** » Sun Mar 16, 2008 6:42 am

adrahil wrote:Boot the MS IPL, load some of sony's PRXs and access flash normally. It is NOT recommended being a smartass and rerouting the TinyFat accesses to flash :) (Unless you want to destroy your IDStorage)

Thanks adrahil.
Don't want to destroy any IDStorage by using the TinyFat system, what sony prx's do I need to load?

adrahil · Post by **adrahil** » Sun Mar 16, 2008 8:42 pm

The basic firmware :) You can look at what is loaded by Desperator Cemeterio for an example.